It is installed in ELIMINATOR 250V which does not select at all when exhaust system is exchanged with new article from now.
There is not much difficulties with regard to installation. Exhaust pipe and engine, Silencer Holder removed, the exhaust system will come off. As a precaution, when you order Gasket outside the company such as KITACO at the same time, if you prepare with KITACO only with XK - 05 etc., Gasket will not attach to SIDE 's Exhaust System. Looking at conformance, Quantity : 2pc. Set It is necessary, but this is used for Manifold of Exhaust which is attached to the Front and another part to the Engine, so it is necessary to have a Gasket for the intermediate joint part when replacing the Exhaust System. If you buy K-PIT's K-04 by looking at the OEM's Parts List Large is durable.
Because the sound is Elimi which is not originally like American, De Fault is not a bass doodo dogo but a high-pitched sound. This item is hard to understand because no sound is recorded on certain movie sites etc, but it is a feeling that Drag pipe etc made by ER which does not customize Inner silencer is close.
There is no Instruction Manual but the position of the OEMBolt used for fixing the Exhaust System is only on the paper of WhiteBlack printing, but the work itself is easy if it fails with the provision Torque and Gasket. Although I do not understand a part, I called a Manufacturer, but the correspondence was very polite.View Detail
These pipes are well made,but fitting is akward because of the larger diameter pipe.The front pipe sits too low and is easily scraped on right hand cornering.They are exstremelyLoud,even with the baffles in.I would think illegal for street use.Would have been a great purchase,if the manufacturer had made these quieter.I had to take them off after about 20 klmsView Detail
These pipes are well made,look great and sound great.I have left the baffles in and they have a great deep rumble,like the bigger cruisers.They are also weigh much less than the stock system.I had to replace the stock exhaust mounting nuts on the front cylinder with normal size 8mm nuts to enable fitment of the front pipe.The rear pipe is much more difficult to fit to the engine, because the bigger diameter of the new pipe leaves little room to tighten the bottom bolt properly.It is hard to get a proper gasket seal.I am going to have to get some heat shields on these pipes to avoid burns to my right foot and leg.Delivery of pipes to Australia was about 3 weeks.View Detail
Probably the best exhaust system you can get for Dragstar 250. Very well made and polished to the highest standard, much louder than original exhaust, which is actually cool. Very easy to install, do not require any modification. View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!